• State Not Answered
  • Replies 36 replies
  • Subscribers 9 subscribers
  • Views 8423 views
  • Users 0 members are here
Options
Related

Altimeter problem after upgrade to 15.20 firmware

Hodo65
over 3 years ago

After updating the firmware to version 15.20 I have with my Garmin fenix 5x plus similar problems with altimeter as described  HERE. Has anyone noticed a similar problem or I am alone? 

  • 0 over 3 years ago in reply to Hodo65

    Thx for the report, Hodo65.

    What about the auto elevationcalibration at the start of and during outdoor activities? I mean  using the gps and dem data for that. Does it work for you?

    See forums.garmin.com/.../1270429

  • 0 over 3 years ago in reply to Tisztul_A_Visztula

    My automatic altimeter calibration setting is: during activity off, not during the acitivity on.  I always calibrate the altitude using DEM before the activity. Recording altitude during activity at this setting seems to work correctly, at least for me.

  • 0 over 3 years ago in reply to Hodo65

    So you cannot be a reference related to my question.

    Hodo65 said:
    during activity off,

    Anyway thx for the reply

  • 0 over 3 years ago in reply to Tisztul_A_Visztula

    I can try with the setting "during activity on", but it will be on Sunday or Monday at the earliest. If I have time to try it, I'll let you know the result.

  • 0 over 3 years ago in reply to Hodo65

    Thx

    let me highlight that in this case  any tests make sense only if you avoid the calibrations listed in points 1-3.

    • Continuous Mode - During activities, the watch uses DEM mapping data, and GPS elevation to offset any altimeter drift due to pressure changes caused by a weather event during an activity. Continuous Mode will allow the watch to calibrate altitude throughout the activity.
      Note: "At Start" calibration will also occur when Continous Mode is enabled
    • At Start - The goal of "At Start" calibration is to provide a consistent relative starting elevation for users that do multiple activities at specific locations. It will not calibrate again during the activity. When the timer is started the watch will try to determine the best elevation source to calibrate to, based on the following priority:
      Click here to view priority list
      1. Manual calibration immediately prior to starting the activity
      2. Prior manual calibration point at the same location
      3. Recent manual calibration, if the quality of the calibration is determined to be good enough
      4. Map data (DEM), if available
      5. Prior Connected DEM point at the same location:
        • Connected DEM refers to elevation data from the Garmin Connect app on a paired smartphone
      6. Connected DEM, if currently connected to a phone
      7. Prior GPS point at the same location
      8. GPS, if a good fix has been acquired:
        • After acquiring a GPS fix the timer ring will turn yellow. At that point, it can take up to 30 seconds for the GPS elevation to settle. If vertical speed settles to less than .1 m/s the GPS elevation data will be considered good enough use for altimeter calibration.
        • Before starting the timer, the elevation data field on the watch will preview the calibrated elevation
    • Off - The watch will not perform any calibration during or at the start of the activity.