This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Altimeter problem after upgrade to 15.20 firmware

After updating the firmware to version 15.20 I have with my Garmin fenix 5x plus similar problems with altimeter as described HERE. Has anyone noticed a similar problem or I am alone?

Top Replies

Tisztul_A_Visztula over 4 years ago in reply to Hodo65 +1
Thx

let me highlight that in this case any tests make sense only if you avoid the calibrations listed in points 1-3.
- Continuous Mode - During activities, the watch uses DEM mapping data, and GPS elevation…

All Replies

0 Tisztul_A_Visztula over 4 years ago

Yes, I have.

Normally this sort of phenomenon had happened before 15.20, but only after getting out the bathtub. Yesterday I faced it without immersing my Fenix into the water.

I did a manual altitude and barometer recal, and since then no problem.

0 toni-rg over 4 years ago

0 ted360 over 4 years ago

Well for me 15.20 was supposed to fix altimeter issues I was having in some activities but never during a run. After upgrading I went on a first run and look what happened: connect.garmin.com/.../6799939247

Someone really screwed this up. I don't know where to start, everything is so messed up. I supposedly went from 287 meters to 12 500 meters yet ascent and descent show 53 and 807 meters respectively. And could someone please tell me how the continuous altimeter calibration is supposed to work? Because it's pretty clear that it ain't working. I've had enough of these altimeter issues. Been writing to Garmin for 3 months now but they say it's a software issue. Well they clearly didn't fix it with this update :/

0 DAPE-BRNO over 4 years ago

Till 15.20 altimeter was OK. After the upgrade to 15.20 exactly the same problem. I rebooted watches and after that seems no problem (at least I did not noticed).

So, try to reboot.

0 RingoSurf over 4 years ago

Yes I confirm !!! after downgrading to 14.00 it's perfect again

0 RingoSurf over 4 years ago in reply to DAPE-BRNO

seems to be ok but you must to downgrade to 14.00 to solve

0 DAPE-BRNO over 4 years ago in reply to RingoSurf

In my case reboot solved the problem with the altimeter. With 15.20 works ok now.

0 Hodo65 over 4 years ago in reply to DAPE-BRNO

Restarting the device was the first thing I did when I found the altimeter problem after upgrading the software to version 15.20. Unfortunately, the problem persists.

0 Hodo65 over 4 years ago in reply to RingoSurf

I would try the downgrade to14.00, but I don't have an installation file, unfortunately.

0 ted360 over 4 years ago in reply to Hodo65

Did you experience similar problems to mine during an activity or is it just outside of activity?