App causing device reboot

Hi,

A user using an s62 reported their device rebooted when they change the run autopause setting in my app. Doing this saves true or false to a key in storage and then pops the menu view.

I am not explicitly checking for 'has' storage before doing this save.

I've asked them to try saving other settings to see if it is a storage issue, and asked for the err_log.txt file if there is one and the ciq and software version.

I can't recreate on the simulator.

Anything else I can do to pin it down, or anything obvious I might be doing that I shouldn't. Will share the code when I'm at a pc, but it's only a couple of lines to save the value then pop the view.

Thanks

0 Dresbo over 5 years ago in reply to jim_m_58

You make a very good point as I neglected to appreciate that it may get a gps fix on the watch while he was testing it.

I'm 99% sure this is the code I gave him and I can't understand then why the menu doesn't close. This is the only version I gave him with everything else stripped out so it should be obvious to him if it was the correct one.

As I say, in the real app the device reboots when he presses this button to save the selection, and the back button doesn't work.

I could add a back button and save during the onback, I guess.

He is the only person reporting this behaviour.

0 flowstate over 5 years ago in reply to Dresbo

But there is no onBack() for Menu (as opposed to Menu2).

I know it's just for testing, but it's also kind of awkward to mix Menu and Menu2 (as the visual appearance is quite different).