This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

27.13 - Course recalculation stops at 80% if I detour

Oren

On 27.13, if I'm following a course, especially long one, of ~30Km, if I detour and recalculation starts (as I want it to be) it will not finish and hold on 80% until I return to the original course, and then gets the "course found" notice.

  • 0 in reply to Oren

    Removing the 3rd party map I had didn't help.

    I did another factory reset and also removed the local map teh garmin shop installed on the day I purchase.

    Let's see...

  • 0 in reply to simacekjakub

    What problem do you have with 400km route detouring? I usually use 500-600km routes with no problem, but never try to detour. 

  • 0 in reply to bikepc01

    Yes, but on some of my routes I can change it. When I try to change it and save the route, it still keeps the same rerouting mode.

  • 0

    So with the latest software and after full reset where I was left only with the original most update (10.2025) maps, it begun well but to the end of the course when I detoured, it was not even getting to the calculation 80% but went straight to the "Error calculating route".

    I even tried the ask to get a course to the start point, directly and got the same error.

  • 0 in reply to Oren

    On my Edge Explore 2, after the last software update and some fiddeling around to get the Topo Active Map EU-West installed, I observed once the same "Route Calculation Error". Stopped the navigation, removed the course from cache, reloaded the same course and 'Ride' (then follows new TBT calculation to 100%). At next deviation from course at the same location recalculation completed successfully as was the case at next deviations / recalculations.

    Also, my experience is that sometimes you need to re-cache courses before riding to avoid 'ghost' effects, strange straight calculatd route-lines, etc.. Maybe after major map changes the pointcache data get corrupted?

  • 0 in reply to bikepc01

    Thank you for your reply.

    I was wondering if your case matches mine, as this time, after the reset to default+removing all maps except the Topo Active of middle east I had no course and only asked to return to my starting point.

    Of course this builds a course, but even when I got the 1st error and then asked again for back to starting point I got the same.

    It might uses the same course, can't tell, but i surely don't know how to handle it while in the mountains w/o a laptop...

  • 0 in reply to rbclass

    @rbclass It starts to recalculate, but it takes so long time and mostly it ends with an error "unable to reroute" or something like that. But it catches back when I come back on route.

  • 0 in reply to simacekjakub

    I dont know, i have it set up to prompt me before recalculation, so it never does it autmatic and i never do it manually

Copyright © 1996-2025 Garmin Ltd. or its subsidiaries