This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

BUG: Manually adding Sensor with ID

When I try to add a sensor to the 1040 using the ID, the text entry will not allow me to enter the 6th digit of the ant+ ID .

In my case i am trying to an an RTL515

Jay

0 aweatherall over 2 years ago

To pair as a light the RTL needs to be put into pairing mode first. This is done by holding the power on button until the LED flashes purple.

0 Julian Young over 2 years ago in reply to aweatherall

Thanks for the Tip. I had no problem with the first 515 doing exactly , but its the second that wont pay ball. The situation is that I ride Audax (Randonneuring) So tomorrow for example I have a 300k (190 miles) ride that has to be completed in 20 hours to get the qualification time. What i do is ride with one 515 and then swap to the other and let the first charge on a battery pack whilst continuing to ride.

0 aweatherall over 2 years ago in reply to Julian Young

I wonder if their is some logic to only support one radar unit in alight network. I think that may be the case. You can pair it as a second radar so will get traffic warnings, but would have to adjust the light pattern manually.

0 Julian Young over 2 years ago in reply to aweatherall

OK lets keep this one clear. There is a definite BUG you can enter enough digits to add an ANTI id manual.
The is a second tread about the problems of adding a second radar unit to the device. I am add my updates to the
https://forums.garmin.com/sports-fitness/cycling/f/edge-1040-series/326813/second-rtl515-does-not-connect-to-light-network

0 Garmin-Maeve over 2 years ago in reply to Julian Young

Julian Young thank you for reporting. Garmin is aware of this and has a ticket open.

0 Julian Young over 2 years ago in reply to Garmin-Maeve

Thank you