Adding Fenix 6 heart rate to Edge activity

I searched but was not able to find an answer and maybe I am not wording it correctly.

My HRM-Run died. It never connected to my Edge today for my bike ride. Therefore, I have no HRM data in the activity. My Fenix tracked my heart rate as I can see it in Connect during the time that the activity took place.

Is there an easy way to take the heart rate that my Fenix collected and embed it into my Cycling activity?

Thanks!

0 almighty over 4 years ago

I don't think it is possible afterwards. However, you can use your watch in send mode for the heart rate (sensor menu or quick access). The watch then behaves as a HRM and can be coupled as such with your Edge.

I do the same when I forget my HRM.

0 Hammie023 over 4 years ago in reply to almighty

Thanks. I was hoping that was not the case about afterwards.

I forgot that I could send the HRM data from my watch to my Edge. I never looked into it because I always had my HRM strap. So, I will figure it out and try it on my ride tonight. Thanks!

0 Dr Phil over 4 years ago in reply to Hammie023

Hammie023 said:
send the HRM data from my watch to my Edg

If you do, make sure you broadcast from the activity. There are two different ways to broadcast HR. If you do it from the watch the HR detection works differently to broadcasting from an activity. Basically sampling rate is less from the watch.

0 araesq over 4 years ago

Can you explain exactly how to do this "from the activity"?

0 mcalista over 4 years ago in reply to araesq

Sensors & Accessories> Wrist Heart Rate> Broadcast During Activity = On