Resume later and battery

I just noticed that when I resume an activated battery mode is not kept and is in standar.
This happens for all the activities of the coup I suppose that it is a general bug. You can change the mode of the battery when you resume activity, but you just have to think about it. Other person or concern?

Top Replies

crt_hun over 5 years ago +1

You have two ways to setup a power mode to any activity type.

When you select an activity and long press the Up button there is a Power Mode menu. If you setup the mode here, it only lasts until the activity…

All Replies

0 crt_hun over 5 years ago

You have two ways to setup a power mode to any activity type.

When you select an activity and long press the Up button there is a Power Mode menu. If you setup the mode here, it only lasts until the activity is stopped, next time it will change back to the default setting of the activity.

However, pressing the Up button in the activity and go to the activity settings such as 'Run Settings' there is another Power Mode menu where you can setup the default power mode for that activity. If you set it up here, this will be the default power mode even if you resume the activity.

0 Alexis_Lecanu over 5 years ago in reply to crt_hun

I did make the difference, do the test for example, the jacket mode or the fc sensor should not work. Start an activity, then stop and say resume later when you resume the mode is in standar and you notice it because the battery displays less time and the sensor works

0 crt_hun over 5 years ago in reply to Alexis_Lecanu

Ok, I can reproduce the behavior, it seems like a bug. Send a bug report to the outdoor.beta email address, hopefully it will be fixed in the next firmware version.

0 Davesen over 5 years ago in reply to crt_hun

I send a bug report yesterday. They create a ticket for that bug.

0 Alexis_Lecanu over 5 years ago in reply to Davesen

Top thank you very much

0 Alexis_Lecanu over 5 years ago in reply to Alexis_Lecanu

New ?

0 Former Member over 5 years ago in reply to Alexis_Lecanu

Hi, I think it's exact the same problem, i didn't find your topic before - https://forums.garmin.com/outdoor-recreation/outdoor-recreation/f/fenix-6-series/223499/power-mode-after-resume-activity-possible-bug. What was you firmware version? philipshambrook comment that is probably solved in the new beta version.

0 Alexis_Lecanu over 5 years ago in reply to Former Member

I am in 8.74. I'm going to test the new beta