7 day training load not updating in connect

Hi,

Had the watch for a couple of weeks and use mainly for walking, running, swimming etc. I also use an edge 1030 for cycling. Up until a few days ago connect reported what I was seeing on each device. Whereas connect reflects the same figures on the edge, on the Fenix however, for the last 4 days the 7 day training load in connect is stuck and not updating. Connect reports around 713, whereas the Fenix changes daily depending on my activities, currently on around 640.

So far I have uninstalled connect and reinstalled, removed the Fenix and re-added, for good measure I did the same with the edge, unfortunately this has had no effect and the 7 day load figure is not updating.

All other metrics are reflected correctly such as Vo2, ftp, activities and all the other stuff. Fenix is also assigned as the preferred tracker. Curiously though on the daily summary the training status takes its data from the edge, which seems to endorse the fact it is not syncing correctly.

If anyone has any ideas or additional steps I could try to resolve this it would be appreciated.

Thanks

Top Replies

All Replies

0 Former Member over 5 years ago

Same problem Fenix 6x

0 RandoCro over 5 years ago

I have the same problem for three days, it started on 28/11...

I did the same tests but nothing changes.

My VO2 of 29/11 is not postponed either

(fénix 6X Pro 4.30)

0 Former Member over 5 years ago

Same here. Started a few days ago for me as well.

0 Former Member over 5 years ago in reply to RandoCro

exactly the same here. Since 28/11 Training status, training load, VO2Max, lactate threshold, and altitud acclimation are not updating on Garmin connect from Fenix 6x Pro 4.3.

0 C.sco over 5 years ago

Same here. It just happened suddenly a few days ago, when nothing else changed on my end. I've been running the same firmware for close to 2 weeks, had no issues with it until now.

It's frustrating when things that used to work perfectly fine suddenly stop working altogether, for no apparent reason.

0 Maurycy over 5 years ago

Same here. VO2Max from my bike updates correctly, but nothing from running. The only place where I can see it is in the FTP widget.

0 RandoCro over 5 years ago

In addition, at the same time, REM sleep is no longer reported...

0 Loen82 over 5 years ago

I do not suffer from any of the issues described in this topic. I've a 6X Solar with SW4.30, but my gutfeeling says it's not related to the watch but to GC icw ios (I've Adroid).

0 JASRA over 5 years ago in reply to Loen82

I think your probably right. Since my initial post Vo2, ftp, rem sleep and possibly a few other metrics are not being reported as well. I think also my edge 1030 is now suffering the same issue, Ive sent an email to Garmin and will advise any response.

All Pretty frustrating as being a bit of a data junky, looking at this stuff is half the fun !

0 C.sco over 5 years ago in reply to Loen82

I'm using android, and I'm having most of these reported issues. I agree that it's likely an issue with the Connect software though.

Also my body battery has been way off. It stayed at 5% for several days in a row, and last night after a good night's sleep it went up to 27, which seems really low, but at least it's something *shrug*.

All of these things were working fine 4+ days ago. They all quit working around the same time, and it was not caused by firmware changes on the watch.