Hi All - I have been using the CT10 sensors for the last 2 golf seasons and have had no problems with them. I set up a new set of clubs and while most of them are still 100% fine, I have found that starting the last 3 rounds brings up a notice that there is an "unassigned sensor". I am able to pair it again through the watch (prior to starting a round), works fine during the round, and then it happens again the next time.
The strange thing is, I only noticed this happening after the Garmin Golf update that added all of the additional clubs. For example, I had my 7w set up as a 5w prior (and never had an issue with it when set up this way). It's only unassigning some of the NEW clubs that were just added to the pick list, none of the standard ones that were there in the past.
I also added a Cleveland 42 chipping club last week, and noticed upon setting it up as one of the 9hybrid clubs (which I believe is also new), that it showed 2 unassigned clubs yesterday. I fully removed the clubs and sensors, rebuilt the clubs (and created the chipping club back down to a lob wedge), so we will see if it happens again.
The other issue that seems to stick out is that the newly updated clubs (7wood, for example) do not show up in the same order as they should in the watch. The 7wood is listed first, above the driver, which makes me think that I fixed the chipping club by making it a lob wedge, but the 7 wood seems still off.
Anyone else having this issue with some of the new clubs?
(Side note, the batteries are new, they connect perfectly fine once paired, and they work perfectly fine on the course).
