instinct 2 2s bad dimension in sim

as the same is on device, no bug only more code to write

I will have to consult the device specs to make sure it is not symmetrical, but I do believe this is correct.

The display width is measured at the widest part of the display, which extends from the left edge near the light label to the right edge at the vertical center of the sunscreen.

As jim_m_58 mentioned, the pixels on the right edge of the display under the sunscreen are obscured by a grey mask.

I don't have any special code :⁠-⁠). This is the only device with not symmetric screen (visible part).

So problem is with all based on middle width and I have to move some part on drawing left and shorten width. As I've written, more work for only one device.

You'll probably already have special code to use/avoid the subscreen on the I2/I2s and then there are the analog hands on the crossover.  And only B&W on all three devices.

I've already discovered it, when drawn white background....

So no bug but more work/code too draw something center and only for one device...