Complete
over 4 years ago

WERETECH-7776, JAZZ-2402, HESPER-2917, BERLIN-2552

Edge530 datafield ANT communication not work after the device restart

Hey!

I have a datafield which showing my external sensor`s data using ANT communication. It is flawlessly working on Edge 520/520plus since a year. 

If I set my datafield on Edge 530 and start it, it works perfectly. However if I restart the Edge and start the datafield it doesn`t communicate with my sensor, not showing any data. 

If I swap the datafield to another one, restart the device, swap back, and start it, it is working until I restart the device again.

I don`t know how to debug this problem. Is there anyone who met the same problem?  Is there a bug in my program or in Edge 530?

Thanks in advance! :)

DBezzeg
Parents
  • Former Member
    Former Member over 5 years ago in reply to Former Member

    Edge 530 firmware 5.03. A single Moxy connects immediately to the ConnectIQ app, but multiple sensors simultaneously has issues. They might appear after anywhere from 10sec to a couple minutes delay. Turning off a sensor that is connected will allow a different sensor that is already turned on to connect immediately. I tried to capture this behaviour on video: https://youtu.be/dCSqgPe3AuA (video is at 2x speed)

Comment
  • Former Member
    Former Member over 5 years ago in reply to Former Member

    Edge 530 firmware 5.03. A single Moxy connects immediately to the ConnectIQ app, but multiple sensors simultaneously has issues. They might appear after anywhere from 10sec to a couple minutes delay. Turning off a sensor that is connected will allow a different sensor that is already turned on to connect immediately. I tried to capture this behaviour on video: https://youtu.be/dCSqgPe3AuA (video is at 2x speed)

Children
No Data