Complete
over 4 years ago

WERETECH-7776, JAZZ-2402, HESPER-2917, BERLIN-2552

Edge530 datafield ANT communication not work after the device restart

Hey!

I have a datafield which showing my external sensor`s data using ANT communication. It is flawlessly working on Edge 520/520plus since a year. 

If I set my datafield on Edge 530 and start it, it works perfectly. However if I restart the Edge and start the datafield it doesn`t communicate with my sensor, not showing any data. 

If I swap the datafield to another one, restart the device, swap back, and start it, it is working until I restart the device again.

I don`t know how to debug this problem. Is there anyone who met the same problem?  Is there a bug in my program or in Edge 530?

Thanks in advance! :)

DBezzeg
Parents
  • over 5 years ago in reply to Stephen.ConnectIQ

    The user has reported that the problem still exists on the reversions of 830 firmware that he's tried.  His report is below.

    "I reverted to 3.5 but still experienced the same issue, then I reverted to 3.2 but the issue was still there. I didn't try 2.5. I hope they are going to fix it quickly."

Comment
  • over 5 years ago in reply to Stephen.ConnectIQ

    The user has reported that the problem still exists on the reversions of 830 firmware that he's tried.  His report is below.

    "I reverted to 3.5 but still experienced the same issue, then I reverted to 3.2 but the issue was still there. I didn't try 2.5. I hope they are going to fix it quickly."

Children
No Data