TotalAscent

It isn't clear from your comments above, so I must ask... Are you seeing his behavior on the simulator or on a physical device?

Both :

As I was seeing that in my device, I export to a .fit the session, and add logs for seing what was happening , and I always seen that the info.totalAscent was to '0'.

In garmin connect, on my activity ; I have some ascent, but it seems to be corrected by GPS. If I desactivate the "GPS correction" (in garmin connect) , the total session put me '0' ascent; but this is new; in the past, I didn't have that.

If you see this on the actual watch, is there an option to calibrate the baro altimeter under sensors? I have a va-hr, and that's the case. There's an option to auto or manually calibrate the altimeter.

I've noticed a few times it can be a bit off due to weather changes, etc (it's going based on air pressure).

Also, with the va-hr, there was a problem for a while if you were at or close to sea level and it got a bit confused. (I never saw that myself - I'm 1200' above sea level)

is there an option to calibrate the baro altimeter under sensors? There's an option to auto or manually calibrate the altimeter.

Yes , I did it, but it changed nothing. Even if the altimeter seems to work , I have the altitude that change, but not the total ascent

TIBLAM,

Would you be willing to send us the .fit files so we can look at the data? You may PM me or your may email us directly at [email][email protected][/email].

-Coleman