Why does CIQ WebRequest example work in simulator with FR935 but not with FR945 and MARQ devices?

The CIQ SDK WebRequest example works in the simulator with several devices e.g. FR935 but not with FR945 or MARK devices.
When I select FR945 in "Run Configurations" the simulator stops after onStart in WebRequestApp.
Does anybody have an explanation for this behavior?

I am working on a a widget where I can see the same behavior.
Widget works in simulator with FR935 but not with FR945 or MARK devices.

Regards, Udo

jim_m_58 over 5 years ago

I took a quick look at the sample code, and it looks like you have to trigger onMenu() or onSelect().

long press of "up" will cause onMenu() to be called.

put some println calls in the code so you can see when things happen.

udotha over 5 years ago in reply to jim_m_58

Hi Jim,

onSelect() works in the simulator with e.g. FR935.
When you add FR945 to the build targets and "Run Configurations ..." with FR945 the simulation stops before "Press menu or select button" is displayed. Instead "IQ WebRequest" is displayed.

jim_m_58 over 5 years ago in reply to udotha

Ok, that's because WebRequest is a widjet and you have glances enabled. On the 945, press down to move what you see to the middle of the screen, then press the upper right button to launch the widget.

Or, in the sim, go to Settings>Glance View and turn that off.

udotha over 5 years ago in reply to jim_m_58

Thank you very much, Jim.