Music Garmin vivoactive 3. The vibration signal stopped working.

Nothing comes out. If you come up with something write. I'm ready to try. Garmin can't help me.

Hi. If we take your Garmin folder and completely replace my Garmin folder. Before that, I'll copy mine to my computer. And restart the clock. Perhaps the identifier is on the chip in the watch itself, and not in the garmin folder. And we'll just restart the clock. If it doesn't work, I'll put my folder back in the clock. Do you think it's worth a try. It is unlikely that the identifier is in the Garmin folder.

I do not see any changes in the \Garmin folder when I change the settings, so I am afraid it is not going to help. I will do some experiments later, a bit too busy for now to go into a cycle of experiments. 

OK. I wrote off on the forum in my country. Users write that files vital for the watch are protected. You cannot delete them. And if this is a software error, then you can try replacing the \ Garmin folder with a folder from working hours. Garmin can't help me. I will wait for your decision.

Hi. You can compare my engineering settings on your watch with yours. Could the settings fail? Thanks.

My battt Model is 23  2. I see the same on the other screens, no delta.

What is delta? Do you have the same vibration on the screen?

No delta -> nothing is different. I see the same on the vibration screen 1000ms and 50% duty cycle and vibration 22. I think that is just for testing, I cycled through with increasing settings but it defaults to these settings

Hi. You can send me your Garmin folder so that I can try changing it to mine. I understand the risks of turning a clock into a brick. But I have no other choice. All hope is on you.