This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

HRM-Pro not record Running Dynamics

Hi all,

My watch is 945 (ver 5.50) and HRM-Pro (ver 7.10).

The connection between my 945 and HRM-Pro is ok and the connection between GCM with both my 945 and HRM is ok too.

But I do a run activity on my watch, it notice that the connection between my watch and HRM-Pro status is Connected, after I finished activity and check on the GCM app the Running Dynamics did not record!?

Please help me!

P/s: I have reset my watch to default, disconnect HRM-Pro from my watch and GCM and reconnect again, replace HRM-pro battery but Running Dynamics still not record.

Thanks!

Top Replies

3851470 over 3 years ago in reply to Garmin-Brooks +2

I do every thing but not change the running dynamic still not record. Last weekend I send my HRM-Pro back to the seller for warranty. Thanks for your reply!
seilogramp over 3 years ago in reply to DrumPhil +1

DrumPhil said:
so i put new battery in and all good

Was going to suggest that in my first post, but OP said they already changed the battery ...

3851470 said:
replace HRM-pro battery but Running Dynamics…
DPSK over 3 years ago +1

Guys most likely the accelerometer sensor is dead.

Electrical HR sensor is fine.

All Replies

0 3851470 over 3 years ago in reply to Garmin-Brooks

I do every thing but not change the running dynamic still not record. Last weekend I send my HRM-Pro back to the seller for warranty. Thanks for your reply!

0 9438121 over 1 year ago in reply to f|33tStA

I have the same exact issue, have tried what you have tried, and believe it is an issue with either the recording or syncing.