Running/Multisport

Forerunner 945 HRM-Pro not record Running Dynamics

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

HRM-Pro not record Running Dynamics

3851470 over 3 years ago

Hi all,

My watch is 945 (ver 5.50) and HRM-Pro (ver 7.10).

The connection between my 945 and HRM-Pro is ok and the connection between GCM with both my 945 and HRM is ok too.

But I do a run activity on my watch, it notice that the connection between my watch and HRM-Pro status is Connected, after I finished activity and check on the GCM app the Running Dynamics did not record!?

Please help me!

P/s: I have reset my watch to default, disconnect HRM-Pro from my watch and GCM and reconnect again, replace HRM-pro battery but Running Dynamics still not record.

Thanks!

Top Replies

3851470 over 3 years ago in reply to Garmin-Brooks +2

I do every thing but not change the running dynamic still not record. Last weekend I send my HRM-Pro back to the seller for warranty. Thanks for your reply!
seilogramp over 3 years ago in reply to DrumPhil +1

DrumPhil said:
so i put new battery in and all good

Was going to suggest that in my first post, but OP said they already changed the battery ...

3851470 said:
replace HRM-pro battery but Running Dynamics…
DPSK over 3 years ago +1

Guys most likely the accelerometer sensor is dead.

Electrical HR sensor is fine.

All Replies

0 seilogramp over 3 years ago

3851470 said:
The connection between my 945 and HRM-Pro is ok

Are you using ANT+ for this connection or Bluetooth? My understanding is that it needs to be ANT+ for the running dynamics piece to work.

HRM-Pro - Running Dynamics

NOTE: To use the running dynamics features, the HRM-Pro accessory must be paired to your compatible Garmin device using ANT‍+® technology.

0 3851470 over 3 years ago in reply to seilogramp

Thanks for your reply, I use ATN+ to connect between my watch and HRM-Pro not using Bluetooth. I don't know why my Running Dynamics not record.

0 Dr Phil over 3 years ago in reply to 3851470

Are you wearing the strap the right way up?

0 DPSK over 3 years ago

I think strap is not recording or downloading any data to watch.

Try switch off the watch OHR sensor. Do a HRV test to confirm. You need a strap for HRV test to work.

0 3851470 over 3 years ago in reply to Dr Phil

I wear the strap in the right way like the Garmin HRM-Pro instruction.

0 3851470 over 3 years ago in reply to DPSK

I do the HRV test it work fine, the only Running Dynamics does not record.

When I do run activity, my watch notice that the connection with HRM-Pro is connected but the Running Dynamics Data Sreen not appear on my watch!?

Thanks a lot!

0 DPSK over 3 years ago in reply to 3851470

Possible that you just gotten a lemon product.

Contact your seller.

0 f|33tStA over 3 years ago

You added the "Run Dynamics" Datafield in your Run App under "Run Settings"?

0 3851470 over 3 years ago in reply to f|33tStA

Yes, I do. But in run activity they not appear!?

0 f|33tStA over 3 years ago in reply to 3851470

you don't see values during run too? or only in the post workout uploaded to Garmin?
You are using the normal RUN App of Garmin?