HRM 600 recording of SSL stopped during activity

wolf04 7 days ago

Hi,

I discovered a problem concerning the new SSL metrics. I use a Fenix 8 pro and the HRM 600 paired with Ant+ secure. In 4 of my 7 runs I did the recording of the SSL metrics stopped somewhen while all other metrics like ground contact have been recorded until the end. I also saw some gaps in recording of the SSL. I am not sure if its an issue of the HRM600 or of the Fenix 8 pro. Has anyone else discovered the same issue?

0 S.M.R. 7 days ago

When there were gaps , was GCT Balance recorded still or not? Most of the other metrics of running dynamics can also be recorded without the HRM (apart from GCT balance). On my 965 my "test" to see if the HRM is dropping out is to look at GCT balance because of that.

If GCT Balance is also dropping out then it would seems to suggest the HRM - watch connection is dropping.

May be worth removing the HRM connection and setting it up again.

0 wolf04 7 days ago in reply to S.M.R.

GCT and all other metrics were fine. The gaps are very small just some seconds. The main problem is that the reording of SSL stopped completly after some time and did not come back while the other metrics have been recorded as normal