This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

HMR-Run showing only cadence from running dynamics.

Hello,

I'm using Instinct watch + HRM-Run. The sensor is pairing and showing the heart rate (I see that the watch sensor is turned off) during workout.

My problem is that I see only Cadence from the Running Dynamics statistics:

My HRM-Run is:

M/N: А02293
IC: 1792А-02293
FCC ID: IPH-02293
ANATEL: 2654-15-3330

Firmware version is 3.40.

Any idea why nothing except cadence is shown? Like Ground Contact Time and so on.

  • Compatible Watch List

    NOTE: Watches marked with a * below indicates they are not compatible with the Running Dynamics Pod and require the use of an HRM strap.   

    • D2 Bravo*
    • D2 Charlie 
    • D2 Delta Series 
    • Descent MK1 
    • Descent Mk2 Series
    • Enduro Series
    • fenix 3 Series*
    • fenix 5 Series 
    • fenix 6 Series 
    • fenix CHRONOS 
    • Forerunner 245/245 Music 
    • Forerunner 630*
    • Forerunner 645/645 Music 
    • Forerunner 735XT
    • Forerunner 745
    • Forerunner 920XT*
    • Forerunner 935 
    • Forerunner 945 
    • Marq Series 
    • quatix 3*
    • quatix 5 
    • quatix 6 Series 
    • tactix Bravo*
    • tactix Charlie 

    The epix, fenix 2, and Forerunner 620 display cadence, ground contact time, and vertical oscillation when paired with an HRM-Run or HRM-Tri. These products are not compatible with the Running Dynamics Pod. 

    To learn more about Advanced Running Dynamics, see Related Content and the following video: