This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Anyone have their running dynamics pod fail out of the blue - mine has

Mine was showing low battery on the last run it worked. The next run it wouldn’t connect so I changed the battery and it won’t connect so I assume it’s dead. Anyone else have theirs fail. Mines out of warranty so unless someone has an idea how to get it going, time for a new one I guess. I did try two batteries and tested both as good. The battery that was working with it is dead as the fenix suggested on the last run where it worked.

Top Replies

tmk2 over 3 years ago +1

When replacing batteries, after removing the old battery wait at least 30 seconds before placing a fresh battery. After that, make sure you wake up the pod by shaking it vigorously or making some dynamic…

All Replies

0 tmk2 over 3 years ago

When replacing batteries, after removing the old battery wait at least 30 seconds before placing a fresh battery. After that, make sure you wake up the pod by shaking it vigorously or making some dynamic steps.

0 vanhalen26 over 3 years ago in reply to tmk2

Thanks. I tried that, no luck.

0 MoggsterLondon 11 months ago

Yes. No help from Garmin as out of warranty. It last 3 years only. I had to suck it up and buy a new one. A bit of discount would have been nice. Garmin has been good with my on customer service for wearables.

0 180TriFusion 10 months ago

My original sensor fell apart at the screw holes. the replacement Dual doesn't give run dynamics. REally dissappointing.