Power LED flashing red/green

Former Member over 5 years ago

Updated to Firmware 3.3.40. Since then, every time I turn the unit on the power LED flashed between red and green and I can't connect it to anything. If the firmware is at fault, how do I roll it back?

Top Replies

Garmin-Matthew over 5 years ago +0 verified

If you are experiencing this issue, please reach out to Garmin Product Support (https://support.garmin.com/en-US/) for additional troubleshooting.

All Replies

0 Jabuinn over 5 years ago

The same with Tacx Flux S..

0 Former Member over 5 years ago in reply to Jabuinn

Did you get a solution?

0 Jabuinn over 5 years ago in reply to Former Member

Garmin Support suggests to exchange Flux.

+1 Garmin-Matthew over 5 years ago

If you are experiencing this issue, please reach out to Garmin Product Support (https://support.garmin.com/en-US/) for additional troubleshooting.

0 emanuelesalati over 1 year ago

you solved?

0 krijnsnuif over 1 year ago

I had the same LED sequence (red-green-red-green blinking of the power LED) on my Tacx Flux 2. This made it impossible to connect my trainer and there were no numbers showing for power, speed, and RPM.

My workaround: I put a distribution plug in the socket and connected my fan (turned on) to that distribution plug.

That helped to connect the trainer to my app (Power LED turned green).

I could use the trainer again, using power & RPM input from my pedal powermeters. Afterwards I found out that the speed was not correct, but the good news was that I could use my trainer again (for a simple 30min recovery ride in Zwift).

Still think that my trainer is defect, but at least I managed to get it working again.

0 emanuelesalati over 1 year ago in reply to krijnsnuif

I sent the tacx to Garmin, let's see what they tell me.
Will update

0 CassioVidal over 1 year ago in reply to emanuelesalati

Any solution to this issue? I have the same problem with my TACX FLUX S