This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Tacx flow calibration.saying too loose but cannot tighten any more

shellhindes over 4 years ago

I have a tacx flow that I am trying ot calibrate.

It keeps telling me too loose and to tighten but I cannot tighten any tighter

Help please

0 L.Rouge over 4 years ago

DC Rainmaker has some hints re Flow calibration in his review.

What size wheels & tires?

Which frame mounting holes (upper or lower) are you using?

How are you calibrating (TACX Utility App, TACX Training App or on a device eg Garmin etc?

My related experience below but might not be your problem ?

0 shellhindes over 4 years ago

Thanks for reply

I am using 650 wheels with setup in top holes.

I am calibrating using the utility app.

I have now tried tightening so much the tightening bolt has come off

0 L.Rouge over 4 years ago in reply to shellhindes

It only takes a few minutes to change so I would try with the resistance unit mounted in the lower holes.

I could never get the Utility App to calibrate at all but the Training App and Garmin Indoor Trainer calibrations worked fine.

Otherwise Garmin Support?

Good Luck, hope it works out ok

0 shellhindes over 4 years ago in reply to L.Rouge

Thank you for reply.

I have contacted Garmin and they are replacing my roller unit. I'm guessing as resistance bolt has come unattached