This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Varia UT-800 not seen by Edge 1030 Plus

Upgrade from Edge 1000 to Edge 1030 Plus everything ok except for the UT-800.

I've setup the 1030 Plus from scratch, not importing sensors.

The Varia UT-800 is not even shown when searching for sensor (either All or only lights)

You can add it manually via the ANT id, and it will connect, but as soon as the RTL-500 is connected all the lights are disconnected.

I've try to remove the radar and search for the headlight, no luck.

UT-800 Firmware: 2.40

Edge 1030 Plus Firmware: 2.30

Top Replies

aweatherall over 3 years ago +1 verified

Did you put the light into pairing mode?

All Replies

+1 aweatherall over 3 years ago

Did you put the light into pairing mode?

0 Lain_OTN over 3 years ago in reply to aweatherall

That did the trick... So long not pairing this thing, Imagine since the Edge 1000
But light network formation is a bit of a lottery, sometimes is quick, other times it takes forever, literally no network formation, has to reset the lights. The edge 1000 was way more consistent.