This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Varia Vision 3.10 Bug with Strava Segments

Hi,
I found an annoying bug when using the Varia Vision display and finishing strava segments.
When the strava segment ends, the varia display reboots but instead of connecting back to my Edge 1000, it connects directly to the Varia Radar which I'm also using.
My Edge unit however remains in a "Varia Vision connected" state, so I'm unable to reconnect.
I can only reset all states by switching off all units manually, thats's pretty stupid, especially at 25 mph :mad:

0 aweatherall over 8 years ago

Could you post the Garmin\Debugging\err_log.txt file?

I was not able to get my set-up to duplicate what you are seeing, but I will pass your error log on.

I rode with the HMD, RTL (500) and Edge 1000.

The HMD restarted. At first it connected to the RTL, but then short while after that it re-established the communication with the Edge. I rode through 4 segments today and it repeat this each time.

0 bradtipp over 8 years ago

Hi bradtipp,

I'm assuming that you don't have the RTL (Radar) in your set-up?

No I don't.

0 noahpene over 8 years ago

I experience the same rebooting problem when the virtual partner finishes a Strava segment

Varia: 3.10
Edge 520: 7.2
Radar: 3:40
English

0 Former Member over 8 years ago

yep same reboot issue for me at end of segment latest firmware for varia and edge 520

0 IBING over 8 years ago

Reboot here as well

I have the same problem with Strava segments. Varia Vision reboots upon finishing the segment.

Edge 520: v. 7.20
Varia Vision: v. 3.10