Di2 battery level display used to be shown as a number, now it's an icon. Can I change it back?

So the Di2 battery field is unchanged, then?

The Di2 battery status is changed to match the same style as used by SRAM and Campagnolo.

All three systems now report the status of the batteries using battery icons. The battery icon bars turn red when the battery status is low or critical. (2 or 1 bars showing)

The difference for SRAM is that it now reports all batteries in the data field and not just the status of the battery with the lowest level.

aweatherall said:

The difference for SRAM is that it now reports all batteries in the data field and not just the status of the battery with the lowest level.

I've got SRAM Eagle and I can see rear derailleur icon only. No Eagle controller icon. In fact, there was another icon for controller too, right after firmware update. It disappeared right after sensors were connected actually.

I have quarq pm too (sram now). No battery indicator for that one either.

There is no battery icon for power meter batteries.

For SRAM I have seen the issue you described and people had to go back and re-pair the shifters to the RD to get the values to come through. Especially after a software update to the shifters.

Re-pairing shifter and RD did the trick. Thank you!

and the quarq already appears?

No no quarq. In fact, I didn't touch it. I re-paired shifter and RD, kind of SRAM pairing, not sensor pairing with edge.

I don't believe quarq pm is supported, as aweatherall mentioned. After all, battery field is in the gear category and gear here means gears like in transmission, not a "all my gear" sense. At least it is that way in my localized edge's user interface.

Some people may prefer a graphical display and I could understand adding that type of field. Eliminating the numerical field just doesn't make sense.

I prefer the % value