New 4.10 Software

Of course, with the Garmin Edge 1030 it works properly.

I had a similar issue and contacted Garmin support. Problem was I wasn’t putting the light into pairing mode, I was just turning it on.  So then edge only picked up the radar part.  You need to do the long press on the light to put into pairing mode and then your edge will detect the light portion.  

I cannot install this update.  When I go into Garmin Express it says no updates available and my firmware is only at 3.50.  But Matthew says the rollout is 100%.  WTF?  GPS not functioning.  Take a look at my out and back ride yesterday.  The location is nonsense.  

The radar still does not work.

1 ride and the only problem was a instant disconnect with di2 it reconnect at the same time  

total time 2,5 h (1 disconnect di2)

di2 via ant+

edge 830 4.10

p2max via ant +

speed and heart via ant ant+

with 3.5 no disconnection

Could you expand on what is not working with regards to the radar?

I'm able to pair and use an RTL510 without issue.

Thanks for the report.  I have zero issue with Di2 connectivity on 3.50.  If I have issues with 4.10 I will revert back to 3.50.

I can only pair one of the two. Either the radar or the light. When both devices are in the sensor list, he connects only to the light. then i must delete the light sensor. after this, he connects to the radar. 

What model of radar unit do you have and what software build is it running?