This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Stages low battery indication

One of bugs in 3.50 is that shortly (several hours) after placing new battery in Stages crank power meter Edge is showing low battery indication. Whereas mobile stages app is correctly showing full battery. Please fix this in new software.

Top Replies

macko68 over 4 years ago in reply to aweatherall +1 verified

ANT. Always prefer this connection

All Replies

0 aweatherall over 4 years ago

Are you paired over BLE or ANT to the Stages power meter?

0 klaenen2 over 4 years ago

Same issue here. It also shows calibration value "0" when you calibrate, even though it says calibration successfull

+1 macko68 over 4 years ago in reply to aweatherall

ANT. Always prefer this connection

0 macko68 over 4 years ago in reply to klaenen2

Then you are connected over BLE. Over ANT I have no problem with calibration

0 aweatherall over 4 years ago

Is this in the sensor details about page or as a pop-up warning?

0 macko68 over 4 years ago in reply to aweatherall

Pop up warning and in sensors power is marked yellow

0 klaenen2 over 4 years ago in reply to macko68

I've switched to ANT now and calibration issue is indeed solved.

0 macko68 over 4 years ago in reply to aweatherall

Turned out I was on BLE (Though I'm almost sure I paired with ANT). ANT+ is not giving false low battery warnings. Its BLE that needs to be fixed.

0 aweatherall over 4 years ago in reply to macko68

This is due to the nature of the way the BLE specification has been implemented.

In the ANT profile it is the sensor vendor that determines the status of the battery and transmits as status code that corresponds to values like Good, Low etc.

In the BLE protocol it does not send a status, but rather a battery %. It is then up to the head unit manufacture to determine what that % means. There is no agreed mapping between % and status.