How do I set-up GARMIN 530 Shifting sensor to work with Sram Eagle AXS 1x12

I would suggest selecting a front chain ring where the outer ring matches what you have on your 1X or create a custom chain ring set with both rings being the same size.

What build do you have on the unit?

I see 3 Gear Presets for 12 speed

10-26

10-28

10-33

Well, maybe not the best answer, but I had no problem at all with this... se photo  (Forreste = front ring & Bageste= Cassette)  I think the trick is to use "user defined" for the front ring and cassette, and enter the number of rings front and rear...

I see a "10-52 (X12)" preset but when I select it, the Edge only shows 11 of the gears, dropping off #12 (10T).  Any suggestions?

What build are you on?

• Software is up to date — Version 9.10

Getting ready to install the 9.24 beta

Called2RideMTB Does your unit show 11 or 12 on the previous page (where there is a number for front and rear gears)? If it's 11, it'll probably only pull 11 of the 12 gears out. nghpmc above has a picture with the right range and 12 listed. Is yours saying 11 or 12? To clarify, the shifter is physically limited by its design. If it's not SRAM Eagle AXS 1x12 as listed in the thread title, it may only be an 11 speed system and then selecting the 12 gear configurations doesn't make sense. Garmin should filter those out but what are you gonna do?

Any news on that?