This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Campagnolo EPS V3 as remote?

On my edge 820 I use the shifters on my Campagnolo EPS V3 to scroll through the pages and to activate the lap function. I can't seem to get that working on the edge 530.
Can anyone guide me?

0 robopongo over 2 years ago in reply to aweatherall

where is that informacion about campy EPS . what manual ?

0 gfk_velo over 2 years ago in reply to robopongo

You should find this helpful:

www.campagnolo.com/.../eps_v3_garmin_connection_to_v3_eps_and_settings_with_garmin_edge1000_and_garmin_edge520_models

I will check with the factory, whether Campagnolo implemented full interaction with Edge 530

0 gfk_velo over 2 years ago in reply to gfk_velo

I spoke to my opposite number in the Service Dept at Campagnolo early this morning.

In translation (so maybe some loss-in-translation from what he said) - he tells me it works on the 530, set up is the same as with other Garmin devices, so you need to enable the sensors just the same - but since the last revision of the firmware, there is a difference ... after about 35sec, the device sensor connection goes into "sleep" mode.

It means that, if you press the MODE button to scroll or set a lap, after 35sec, the Garmin behaves as if the sensor has just been "woken up" - the may be a short delay and a tone, telling that the sensor is connected.

Once the sensor is "woken up", the connection works as it does with G1000, 820 and 520.

0 robopongo over 2 years ago

now is working .problem was eps remerber last garmin 830 . during pairing i press mode buttom times , and left button 5 times . and then i show remote on garmin displey.

0 gfk_velo over 2 years ago in reply to robopongo

Ah, great!
Glad that the resetting routine worked for you.
I have seen cases where the Garmin needs to be rebooted, as well as the EPS system needing to be disassociated from another unit. Semms that is what worked for you.