This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

The Edge 1040 is still dropping the Power Meter.

The Edge 1040 is still dropping the Power Meter. I am running Vector 3 pedals and have firmware 12.15 on the 1040. Out for rides Weds and Thurs and both days got the Disconnected / Connected messages popping up and loss of data. It seemed to disconnect every 30 seconds or so and then reconnect about the same after. Any clues as to when this will be fixed? As it is the unit is useless to me as I train to Power and Cadence - neither of which work!

Top Replies

All Replies

0 Michael_Kalina over 2 years ago in reply to JvLandenberg

EDGE 1040 (SW 17.26) dropping Shimano Ultegra with Giant PowerPro power meter

0 Stempnakowski over 2 years ago

Since 17.26, I have been constantly bombarded with Right Power Meter Missing messages. I put fresh batteries in just before the last ride, and everything showed 100%. After updating to 17.26, I did have to remove the Vector 3s and then add them back because the Edge 1040 could not connect after the SW update.

0 cschoenf over 2 years ago in reply to JvLandenberg

the issue was fixed for months at least for my rotor inspider, AND came back with the latest update on 1040. totally annoying

0 felipenovais11 over 2 years ago

I don't know if this was just luck because it is kind of random, but if I pair the inspider via Bluetooth and ANT, enabled both, bue only connect with the Bluetooth, it won't drop anymore and it will calibrate. Anything different than that I was not even able to calibrate it via Edge. I used it 6 times this week without any disconnection.