This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

iOS Setup

4/10/2024

Just got a 1030 Plus, followed instructions, played around with trying to connect until I got frustrated and resorted to the internet.
For me, the garmin shows up in my iPhone Bluetooth, I can connect and pair but it isn’t fully connected - has to go through the app too.
So I open up the “Select an Accessory” tab and have to wait 4.5 minutes (I’ve timed) until I can view the device is available to pair. However! At that point the app has timed out and I can’t pair the device. Each time I go and “forget” the device in my Bluetooth to start over as well as restarting both my phone and the garmin.
A little frustrating for “top of the line” technology.

in the image you can see the “retry” button at the bottom indicating the timeout

0 PeterK_55 7 months ago

See these instructions Pairing Your Smartphone

You either need to go through the GC mobile app if pairing from the phone or alternatively manually start the process from the Edge.

0 mcinner1 7 months ago

This answer is usually not needed - but since it has already happened to me: when the popup comes with the device found (BT Edge 1030...), you have to tap on that device!