This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Edge 1030 Plus V5 VO2Max Performance condition not updating

Hi,

my Edge 1030 Plus does not update the VO2Max values nor does it show the performance condition popup since the update to V5.

The performance condition data is entirely missing from the fit file too.

It behaved normal with the previous software and since the V5 update it doesn't update those metrics anymore.

Training effect etc. is updated still.

I've reconnected all sensors (HRM, power meter, speed sensor) but this didn't help.

I've turned the notifications for the performance condition off and back on again (same for new VO2Max) but this didn't help either.

I've done workouts like before which were providing updates to these metrics.

I've not done a full reset as I am unclear if that would have a negative impact on the fitness data and data on

the device (i.e. if the existing rides etc. would sync back from connect or if these would be missing then)

Maybe there is another solution.

Any help is highly appreciated.

Thanks

Top Replies

9330433 over 3 years ago +1 verified

working again finally - I did a hard reset and forced the Physio TrueUp to sync again by turning it off for the Edge through the GC app and back on again (with sync in-between). Now after a short ride…

All Replies

0 Wongataa over 3 years ago in reply to 9330433

If the training status has been reset it takes a week of rides for it to be regenerated.

0 9330433 over 3 years ago in reply to Wongataa

I see the training status in GC from my Fenix. And I don't remember this being the same case when I first started using the edge after having used the Fenix for tracking the rides. Physio TrueUp should be syncing the training status between the devices. It doesn't do that.

0 9330433 over 3 years ago in reply to 9330433

I disabled Phyio TrueUp synced and enabled it again (from the phone app) and synced. Now the training status is showing on the edge - let's see if it actually starts showing the performance condition again etc. as well after the next ride

0 DavidKroter over 3 years ago in reply to 9330433

My favero are in ant+ mode.

+1 9330433 over 3 years ago

working again finally - I did a hard reset and forced the Physio TrueUp to sync again by turning it off for the Edge through the GC app and back on again (with sync in-between). Now after a short ride I'm getting updated values for VO2Max and performance condition was shown during the ride too.

0 DavidKroter over 3 years ago in reply to 9330433

My favero in Ant+. i am not sure if the hard reset was the fact that reppaired the Vo2 updating fix. But now is updating.