New Fenix 6 series software v4.10 and SNS 2.50

phoglund_ over 5 years ago

We are currently phasing out SW 4.10 and sensor hub 2.50 for the Fenix 6 series of devices. This is at 20% right now.

------------

Didn't see this one until now, 11 hours later

Anyone that got the update? Comments?

Top Replies

Former Member over 5 years ago +5 suggested

Updated mine. However, the volume control won't work on my Airpods now.
Former Member over 5 years ago +5 suggested

The 4.10 update installed. Some music improvements? Now, I am not able to change the volume with my bt headphones. The graphics of the volume bar is stuck, still the same position...

I would like to put…
Kepa over 5 years ago in reply to Teriemer +4
Change Log
- Added support for on-device videos demonstrating workout steps. These are available for the pre-loaded workouts now available in Yoga, Strength, Cardio, and Pilates apps. Additional workouts…

All Replies

0 bluefish over 5 years ago in reply to ericbfit

If you‘re on the FW 4.10, it should dissappear after about 15 seconds of keep still. When turming wrist, it comes alive again.

0 DCeremuga over 5 years ago in reply to bluefish

If you're on FW 4.10, your music, iphone and airpods should disappear as well

0 bad_one over 5 years ago

Again nothing for APAC versions, at least my Fenix 6X pro is still at 2.40, also beta sensor updates does not work with APAC versions.

Seriously Garmin why is APAC always last and so much behind? Is the hardware or firmware that different?

0 DarrinC over 5 years ago in reply to bluefish

Brand spanking new to the forums. I never paid this much attention to updates with my 5x+ it worked out of the box. The broken sensor hub issues brought me here...

0 Former Member over 5 years ago in reply to DarrinC

Does anyone knows if the Heart Rate accuracy issue solved?

0 phoglund_ over 5 years ago in reply to hammerheadny

hammerheadny said:
Where do I find all change logs for the Garmin Fenix 6X Sapphire

Just look at the top of the forum.

0 LukasZahorec over 5 years ago in reply to PatrickNSF

Same here, first when I connect to bt. headset, earphones will start to play very loud, than when I try to set the volume, volume just goes very low and I cannot set it anymore. (I tried it to remove and add it again, happens all the time)

0 Former Member over 5 years ago

The 4.10 update installed. Some music improvements? Now, I am not able to change the volume with my bt headphones. The graphics of the volume bar is stuck, still the same position...

I would like to put the question here. I run 250m athletic lap, but fenix 6x shows me up to 50m more every single lap. Is that normal? Any tip for the settings, how to get the better precision.

Normally I use gps+glonass. Never use some 3D settings, or etc. Could it be fixed? Thanks for your comments.

+1 harald.zingerle over 5 years ago

Installed SW 4.10/sensor hub 2.50 2 hours ago, did a 30min run afterwards,but heart rate without is still crappy as hell. Instead of heart rate around 160bpm my 6x pro showed between 90 and 125 bpm. .

Guess I will return it, because that's a no go and I doubt they will ever get this right

0 bluefish over 5 years ago in reply to harald.zingerle

Did you used a chest-strap ?