MIPS hardware display issues on Enduro?

Milco 9 months ago

Since the upgrade to v11.64 I noticed a weird and annoying issue, it keeps popping up. Even after rebooting the device. I might go and reset my device, not liking having to do that. For info, I have no other watchfaces, and I did not change the default other then with accent/data colors. If I press light On, or move to different screen is gone.

Top Replies

Tom 9 months ago +3

That is a faulty unit and needs returning to Garmin
6381398 9 months ago in reply to Milco +1

Yep, I tried the master reset also, without any changes.

All Replies

0 Artek_78 9 months ago

Looks like Your Enduro is drunk ;-)

Did You tried software reset? (hold "light" until watch turns off)?

0 Milco 9 months ago in reply to Artek_78

Yes, doesn't solve this the issue.

0 Artek_78 9 months ago in reply to Milco

And how about other watchfaces? Create one in watch, maybe it`s just damaged watchface config file. (On my E3 default watchface works fine albeit i`m not using it, i prefer white background)

0 Milco 9 months ago in reply to Artek_78

I went into, left button, watch face, button down, button down..

Add new watch face... and it still happens. So after this weekend (race day) I'm no other option left then to factory reset and try that I'm afraid

This sucks, I configured some activities.. for running, having to do it over again is a annoying

0 Tom 9 months ago

That is a faulty unit and needs returning to Garmin

0 Milco 9 months ago

v11.67 DID NOT fix the issue.

0 Milco 9 months ago in reply to Tom

It's not only with the default watch face, so I'm gonna call them on Monday and quite sure that it will/has to be replaced. It have the feeling that one of the wires of the display is not connected properly.. to refresh

or some fault in the semiconductors... Meanwhile I did a master-reset, and tried 11.84 in beta enrolled .. none works.

I've paid $800+ dollar's for this thing, this is not acceptable/tolerable..

0 6381398 9 months ago in reply to Milco

I have the same problem with my Enduro 3. It pops up just at the bottom of the face, but looks similar. I went to the Garmin tech specialist and he told me it's a software problem and should be fixed in the upcoming firmware updates. What's your result?

0 Milco 9 months ago in reply to 6381398

I had three or four firmwares in the meantime, nothing fixed it so far.

Master reset did not so anything either, it only looks to be getting worse, I can't even normally use my watch, the time is often not readable

0 6381398 9 months ago in reply to Milco

Yep, I tried the master reset also, without any changes.