Hi,
the D2 Plus offers a way to calibrate the altimeter using the METAR of the closest airport. Does this work for somebody?
If I select this option, what should be displayed in the pressure-reading below the altitude in the altimeter-widget?
What is the correct way of calibrating the altimeter?
According my understanding there should be a way to use the local METAR to calibrate the altimeter to the local QNH, but also to adjust (remove prehaps existing offset of measured altitude, so the indicated altitude corresponds to the actual altitude).
In my case the altitude app shows a lower QNH and not the METAR and also altitude is shown 200 feet below real altitude. If I use Settings->Sensory->Altimeter->Calibrate, then I can calibrate the altimeter to show real altitude, but then the displayed pressure ich much to high (higher than QNH....)
Also the altimeter seems to forget the calibration each time the altimeter is left and opened for another time...
Is there a softwarebug on the D2 version 5.2 ?
Regards,
Florian