Hello everyone,
I am very new to the world of the inReach mini and although i looked through the very informative message exchange I could not find a solution to my problem so I apologise in advance if i didnt find the solution and its already there. Any help will be greatly appreciated.
I had my unit for about a month now and took it out to few outings. In order to log my route I enable the tracking function and i have it set at 2 minutes interval (for my plan the sending to mapshare is standard 10 minutes). I always clear the log, stop tracking and then start it again at the end of my route I always stop tracking. I have created a new collection where the track is saved so when back on the computer and after a wired synchronisation the track is in two places:
i) the sent to mapshare collection and
ii) the one i have created for this purpose.
In order to keep track separately i have a few different collections and after syncing I move it to the appropriate collection. So far so good. Now the problem:
The tracking doesnt start fresh every time but continues from the previous track. the result is that all of them are connected and the very first one keeps increasing in distance and time but it is not possible to see each one of them separately as they are always superimposed with this information. If I run a loop on the same route i followed there are two tracks on the map, the one which is fresh (at 10 minute intervals) and the older one which contains the 2 minute interval information.
I believe i am doing something wrong but after having deleted multiple tracks and attempted to resolve the issue I thought I will ask here in case someone has experienced a similar issue and found a solution.
Thank you in advance for any help
