This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

nuvi 1350T will not boot past the LOGO

Former Member
Former Member
When I turn on my nuvi 1350T the GARMIN logo comes on then goes off then on then off..... and this is a far as it gets. I have tried soft and hard resets, neither of these would work. If I hook it up to my computer it does not show up on the directory. The unit is only 2 weeks old. Is it dead or what?
  • Former Member
    0 Former Member over 14 years ago
    Ok guys, in another thread I found this solution. It worked for me.

    My 1350T was hanging on start (Loader Loading...). With the unit OFF, hold your right thumb on the Upper, Left part of the screen and plug the USB plug from your computer into the back of your GPS. The unit should boot up and stop at the screen where it shows a little computer, wire, and little GPS. Your computer should now show the GPS as connected. Only now you can pull your thumb from the screen.

    I then used Webupdater to upload 4.40 to my 1350T. I'm back in business without the hassel of shipping my unit to Garmin. By the way, they sent me an email with directions to hold the WRONG part of the screen (lower, right); of course it didn't work. At least with my 1350T, you hold the upper, left!!!

    Good luck


    This worked for me! Thanks for posting this!
  • Former Member
    0 Former Member over 14 years ago
    This solution helps me to rectify my Garmin 1250 " loading map" problem too..... thanks.:D