This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Incident detection

9362568 over 5 years ago

How do you set up incident detection to automatically work if something happens during a run?

How does it work? What does it detect? Fall or stop?

0 trux over 5 years ago

Check out for example this article:

https://www.garmin.com/en-US/blog/featured-2/safety-and-tracking-features/

0 9362568 over 5 years ago in reply to trux

Thank you I read the article but it doesn't say how to set it up for detection during a run.

It only says how to send an emergency alert manually!

0 trux over 5 years ago in reply to 9362568

Well, besides the same requirements as for the manual alert (emergency contacts in your settings), the automated alert is indeed automated, hence no additional instructions are needed. I would tell that details about the Incident Detection should be in your User Manual. I cannot give you the direct link, since you did not mention the model you use, but I suppose you'll be abe to check it too.