On a recent video I am pulling together I noticed a glitch where at the transition point from one clip to the next the data overlay momentarily reverts back to the initial values for that clip then to the correct point on the new clip. I will have to check other video's I've compiled to see if it exists there as well(I suspect it does) I only noticed this as my last clip was very short and the only reference point I have for syncing the data to the video is the transition point. I checked and I get this same error at each transition point within this video.
Also noted that playback in edit is now worse than before. it has been worse with each release since 2.5.0, 2.5.0 playback was fine, stable, in 2.6.0 and now 2.7.0 playback has gone from good to slightly jerky to near seizure inducing. I would blame the computer if it I had only tried the most recent version but since previous versions worked I do not think that is the case.
Put together a short 1:45 min video (condensed from 3 hr ride) this morning, was made up of about seven 10-15 sec clips with transitions between.
I have noticed a data lag from one clip to the next and lost data (power and cadence only) on a couple of the clips.
I think (am not sure) that this happened when I "trim right". if I split the clip the data remains. Would trimming right lose some necessary reference point????
