Hi. Just upgraded to 3.60 but when finished I thought something went wrong because I still get the message new sw available. Tried 3 times, same result. Went to Garmin Connect on web and found that my pedals was updated after all. Strange ting is that it says new sw available 3.60 your version 3.60. Why does it not recognize that I'm already updated? Did anything went wrong?
I have different experience. I have a few times "right sensor is missing" error message in the past but it disappeared after the new battery socket closing something that I got + Garmin Edge 1030 software upgrade. Yesterday I noticed the new 3.60 firmware is available for vector 3 (so not the 3s but 3, both side). I upgraded. About 10-12 minutes. It was recognized. This afternoon I went for a ride and I got consistent "right sensor is missing". Finally I had to disconnect the right sensor as it was displayed periodically and only got half of the power. Also before I observed some drops like I pedaling continuously but I see 0 cadence for 4-5 seconds. Also I observed peaks like 1900 watt or 1000 watt for a moment (but it is there).
Has anyone of you experienced similar with most recent 3.60 firmware? Battery has recently replaced (I was cycling only 4-5 hours since) and left sensor looks ok. (I replace battery in parallel and check voltage before. Usually drops voltage to the same level both side. But in this case I did not get low battery warning.)
