Cannot Enable TE/PS & Auto Zero Offset

Curiously after allowing 1030 to reinstall firmware 3.0 was able to engage te/ps & auto zero from 1030 and have it stick where as iPhone/gcm would not

How could the 1030 reinstall the update? If it is already on the same software it wouldn’t update I would have thought?

+1
me too on Android.

Hi. I have exactly the same problem with TE/PS and Auto Zero on GCM not sticking after updating via iphone 6s and 520. Are you also finding it can take ages to first wake up? See Pedals not waking up after firmware 3 update

+1 Two different android phones. as soon as you set them, the bluetooth disconnects from pedals to phone

Auto zero shows up as “off” using GCM on my iPhone and causes the pedals to disconnect when I try to enable it. When I check the status on my Edge 520 it shows up as enabled. I’m just going to ditch GCM since it’s not really needed and everything seems to be working fine otherwise.

Another strange thing is that there seems to be a missing toggle option below Torque effectiveness... and above pedal power phase in the “Vector Features” menu on the Edge 520. I can’t remember what the toggle was but I’m certain that something was there.

+1 I too have an empty row / missing toggle on the 520 screen since the update..

I have reported the issue with enabling TE/PS, Auto Zero toggle issue to the engineering team for investigation.

Same issue here....torque effectiveness/pedal smoothness is disabled. I will enable it through GCM but when I look again it's been disabled. And no such data shows up on my Edge 520 so it seems to really be disabled, and not just a display issue

+1 TE/PS toggle wont stick. I get tge message that the settings will be updated at next sync. But then I lose connection and nothing happens.