This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

v6.10?

Former Member
Former Member
I got an update to my G235 this morning. Just installed it and it's v6.10

Question 1: What is in this update?
Question 2: Did it get taken out and 5.20 re-replaced it?
  • Former Member
    0 Former Member over 8 years ago
    There was an issue that might prevent some users running an older software version from fully updating so the 6.10 software update was removed from production earlier this morning, and the 5.20 version was re-released. Most users were not impacted, and would be able to successfully update.

    We have recently just pushed out the 6.20 version that will allow all users to successfully updated. The change log for the 6.10 and the 6.20 are the same and you can find more information in the sticky thread.
  • Former Member
    0 Former Member over 8 years ago
    Thanks.... so I have 6.10 right now. Will I get 6.20 the next time I sync to Connect and/or Express?

    There was an issue that might prevent some users running an older software version from fully updating so the 6.10 software update was removed from production earlier this morning, and the 5.20 version was re-released. Most users were not impacted, and would be able to successfully update.

    We have recently just pushed out the 6.20 version that will allow all users to successfully updated. The change log for the 6.10 and the 6.20 are the same and you can find more information in the sticky thread.
  • Former Member
    0 Former Member over 8 years ago
    You will get 6.20 software update either through Garmin Express or Garmin Connect Mobile. It can take up to 24 hours for the update to push out to all users.
  • time error

    There was an issue that might prevent some users running an older software version from fully updating so the 6.10 software update was removed from production earlier this morning, and the 5.20 version was re-released. Most users were not impacted, and would be able to successfully update.

    We have recently just pushed out the 6.20 version that will allow all users to successfully updated. The change log for the 6.10 and the 6.20 are the same and you can find more information in the sticky thread.


    After upgrade I have time error: is back about 25 minutes!!! There is automatic time update activated, but there is error anyway. I tried to deactivate automatic time update and put it another time but nothing. I tried to change time zone (+2) and return back to my correct time zone (+1 central Europe) but don't change nothing: how I can solve it?
  • Set back the setting to automatically get time and then go outside and get a GPS lock. This should fix it

    HTH

    CW