8/28/2018 Incremental roll out: 100%
Changes made from version 9.10 to 10.00:
- New Feature: Added Connect IQ 3.0 support.
- Added enhanced support for Varia RTL510 radar tail light. As part of this, all ANT sensor processing code has been improved and should be more reliable.
- Updated the manual activity upload UI. It will no longer be available if the auto upload setting in GCM is disabled, as this prevents GCM from accepting our upload. If auto upload is enabled, it should correctly reflect success when the upload completes.
- Fixed issue where the Edge would no longer connect to old iOS devices after version 9.00's Bluetooth rework.
- Added UI to inform users of the impact of brightness and backlight settings on battery life.
- Added tip to remind users to remove their bluetooth connection from the phone's settings after performing a forget phone action.
- Fixed issue with the device where going into mass storage from a power off state may cause Garmin Express to offer a map update that the device does not need.
- Fixed issue where going into mass storage mode would sometimes be detected as an unrecognized device until unplugging the unit and trying again.
- Fixed issues preventing device-to-device transfers from completing and made improvements to the connection flow.
- Fixed potential crash on the compass page.
- Fixed issue when renewing the phone connection (not common) would cause the Edge and phone to forget each other after a reboot.
- Fixed potential crash when processing audio prompts.
- Improved missed call smart notification UI to more reliably show the phone number instead of 'Unknown'.
- Cleaned up some of the sensor found notifications that could occur in the middle of a ride.
- Fixed battery low prompts for radars when connected as a radar and not included in a light network.