Hi everyone, I have a problem with both the edge 820 and the edge 810 while pedaling standing during a climb. In fact, the indicated speed is halved since I'm sitting and the instrument pauses. I doubt that it may be the cardio band that creates some interference with the signal of the gsc 10 sensor and I would like to ask you if someone has already encountered this problem and if there is a solution. Thanks in advance
I suspect pause is triggering because your speed is low. Change the auto pause setting from When Stopped, to Custom and set the threshold to something like 3 m/h, or 4 k/h
I suspect pause is triggering because your speed is low. Change the auto pause setting from When Stopped, to Custom and set the threshold to something like 3 m/h, or 4 k/h
It is already set so.
Are you sure the speed is coming from the sensor? Lift the wheel off the ground and spin it. Does the Edge register a speed?
It seems that the speed is not coming from the sensor but from gps. How can a change this setting
In my experience, if the GSC10 sensor is paired with the 820 and detected, the 820 uses it. The little speed and cadence icons at the top of the 820 home screen stop flashing when the sensor is paired and detected.
It is possible that the the spoke magnet is not being sensed by the GSC10, which would cause the 820 to revert to GPS for distance.
Even with a constant speed sensor signal I am almost certain the 820 will use GPS first and use the speed sensor when GPS is not available even revert back to GPS when it comes back.
As mentioned above speed from the sensor takes priority over that from the GPS.
Check the aliment of the wheel magnet. There is a line on the speed senor arm, about 1/4 inch from the end. The magnet should pass by that line and should have a clearance of 2-3 mm.
If the magnet is correctly placed then check the battery.
