This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Edge 820 and ANT+ magnetless speed sensor not working

Former Member
Former Member
Hi,

I set up my 820 switching from a 810 this weekend and at first had trouble finding the speed sensor, which I am not using together with the cadence sensor for I use a Vector2 for that. After manually putting in the Sensor ID, the sensor was found and apparently working. When I took the bike for a ride, I noticed that the speed did not exceed 7,4 km/h and therefore my autostop kicked in ... I could not get it going with deleting and re-adding the sensor, so I just deleted it and the 820 switched to GPS speed which is a pain in the *** if you are riding in the woods ... well, back at home, I did not get the speed over 1 km/h anymore, so I checked the speed with my 810 and it just works fine there. Anyone has the same problem or even better a clue on how to fix this problem ?

Thanks
  • Former Member
    0 Former Member over 8 years ago
    I've been using the magnetless speed sensor and Vector 2's (also Edge Remote and Varia radar) with my 820 from day one without problem.
  • Former Member
    0 Former Member over 5 years ago

    Try putting it on the rear hub the other way around. 

    So u can read garmin from the rear of the bike. 

    Worked for me. 

    Good luck