This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

flashing play button; when I start cycling my three sensors seem connected speed , cadence and heart rate however after 5 or so seconds a flashing play button like the following |>|>|> ; any ideas ?

Former Member over 5 years ago

Top Replies

thosj over 5 years ago in reply to volodp +1 verified

Press the START button, lower end, right side, BEFORE you even start and see if it then acts normally! I have AUTO PAUSE set to 3 MPH so I press start and it immediately pauses. Start riding, off it goes…
Former Member over 5 years ago in reply to volodp +1

Hi Volodp, no, re getting going , but I couldn't figure out once I had completed the static turbo session how to stop the process and then I read your answer and that's how you stop it !

thank…

All Replies

0 spiderbundy over 5 years ago

Is that not just the reminder to press the Start button when you get to a certain speed?

0 Former Member over 5 years ago in reply to spiderbundy

Hi Spiderbunny, appreciate that and that makes sense but unfortunately , no matter how fast I cycle or how often I keep pressing the start button it doesn't stop flashing

0 volodp over 5 years ago in reply to Former Member

Are you sure you are pressing the hardware button, one on the front right side of the unit? If yes, to me it would then sound like that button is broken on your Edge.

0 thosj over 5 years ago in reply to volodp

Press the START button, lower end, right side, BEFORE you even start and see if it then acts normally! I have AUTO PAUSE set to 3 MPH so I press start and it immediately pauses. Start riding, off it goes.

0 Former Member over 5 years ago in reply to thosj

thank you ! it was the auto pause I set it to "when stopped " and that seemed to do the trick.

0 Former Member over 5 years ago in reply to volodp

Hi Volodp, no, re getting going , but I couldn't figure out once I had completed the static turbo session how to stop the process and then I read your answer and that's how you stop it !

thank you