This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Di2 Dfly and repeated notifications

i just had a dfly unit installed and synced my di2 to my Garmin 1030. Now every 10-30 seconds my Garmin notifies me with a beep and a little pop up that I’m using shift profile S1. I assure you, I can remember what shift profile I’m in longer than 10 seconds and it doesn’t need to keep reminding me. My only solution was to un-enable the di2 pairing.

Anyone else have this issue and/or a solution?

thanks!

0 aweatherall over 5 years ago

I would use the e-tube phone app and make sure that all the Di2 components are up-to-date on their software.

0 GALIERO61 over 5 years ago

si anche io con la versione 7.50 avevo questo problema con dfly e 1030 ,e ti posso assicurare che tutti i componenti di2 sono aggiornati all'ultima versione

0 JSIEGE11 over 5 years ago in reply to aweatherall

I’d love to! But the phone app says I have a poor connection (despite being right next to the device) and compute app fails to even start up and cable driver won’t load! It’s been an awesome experience all around

0 JSIEGE11 over 5 years ago in reply to GALIERO61

sei riuscito a ripararlo?

0 aweatherall over 5 years ago in reply to JSIEGE11

Sounds like you have some issues with your Di2 system.

0 JSIEGE11 over 5 years ago in reply to aweatherall

As stated below, it’s not the FW of the Di2

0 GALIERO61 over 5 years ago in reply to JSIEGE11

NO ho risolto tornando indietro alla versione 6.30 ,perche ' con le versioni dopo avevo problemi anche con i pedali bepro ,e quindi ti posso dire che con la versione 6.30 sia dfly che bepro e tutto perfettamente funzionante

0 lhol over 5 years ago

I can remember that I had the same behavior when I installed the EW-WU111 unit, but I can’t remember how I got rid of that. I do know that the first thing what was happening when I hooked my system to my computer and ran the E-tube application was that the firmware of the EW-WU111 was updated. Now I get the notification only once when Di2 sensor is detected. Maybe it is a setting in the Di2 sensor details on your Edge1030. Don’t ever update any firmware using the phone app using bluetooth connection. Make your E-tube application on your or someone else his computer work an hook your system on by usb cable.

0 JSIEGE11 over 5 years ago in reply to aweatherall

Verified all di2 pieces are up to date and the issue persists!

0 Martin868 over 5 years ago in reply to lhol

If I recall it was required that the first FW update of the wireless unit had to be done using the computer e-tube app and the usb cable, not the phone app. Once that was done things were working fine using the phone but not the first time out of the box. There was a notice somewhere explaining you had to do that.