This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

1030 and Stages Right-side Only: "0 Calibration"

Hi all,

I am having trouble getting a right-side only Stages power meter to connect properly with my 1030. For starters i've ensured that the firmware is up to date for units. Here's what I've done and what's still happening:

I was having trouble getting the 1030 to see the Stages properly so I followed some instructions in one of the other forum threads and created an entry in the 1030 for the Stages via BLE and ANT+ (not running both at the same time). The ANT+ will not calibrate the Stages... it simply spins and spins trying. Switching it off and the BLE entry on it finds the Stages OK, gives the proper info about the unit, but when I try to calibrate it will only give me "0" reading. And, yes, I've got the crank oriented properly towards the ground. I am at my wit's end. Any ideas why it might not be calibrating properly?

Thanks, George

Top Replies

Garmin-Matthew over 5 years ago +1

jorgegortex - The Stages calibration process is pretty straight forward. It seems the 0 might indicate a problem with the Stages. This link should help you resolve the problem and you might need to reach…

All Replies

0 Garmin-Matthew over 5 years ago

jorgegortex - The Stages calibration process is pretty straight forward. It seems the 0 might indicate a problem with the Stages. This link should help you resolve the problem and you might need to reach out to Stages for additional help. https://support.stagescycling.com/en/support/solutions/articles/1000139569-how-do-i-calibrate-my-stages-power-meter-

0 jorgegortex over 5 years ago in reply to Garmin-Matthew

Thanks. That's what I thought as well. I have a left side crank arm on a different bike and have no problems. I was just checking to see if i was missing something. i am talking to Stages as well. They sort of point back at the other direction, heh, so I will probably need to pull the crank and send it to them for evaluation and repair if needed.

0 Dave_Amo over 4 years ago

Hi George I have the same issue on my 1030 plus it give a successful cal of 0. However it cals perfectly with the Stages app. Did you manage to get a successful resolution?

kind regards

Dave