This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No Vector3 Calibration Notification

Since the latest firmware update (maybe the one before) I do not get any Calibration Notifications anymore when riding with my Vector3. I see power sensor 999999 found in the screen. but to calibrate I have to manually go into the sensors section, select the pedals and select calibrate.
I used to get automatic notifications to calibrate without problems up until a couple of weeks ago. The setting for calibration notifications is switched on.

I also think I do not get any Low Power notifications for the battery status anymore, but as I should get these only once every 30 rides or so I cannot tell wether this is true.

0 rob-tech over 6 years ago

Yes, I noticed the same thing on my recently bought Vector 3 pedals, it worked on the first ride and on the second ride it no longer asked me to calibrate. I had to go into the power meter settings to do it manually.

I have the calibration notification turned on in the power meter settings so it should work.

0 Former Member over 6 years ago

for me it works as before!

what Connection you use? ANT+ and BLT?

i only user ANT+ and disabled BLT

0 Teriemer over 6 years ago

I often have the same issues with auto-prompt "Calibration".

Sometimes I'm asked other times not.

One hint here: If you're not asked to calibrate, then drop down screen, choose right screen 1 or 2 times, then you can choose calibrate from here.