Related
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Edge 1030 frozen during ride

Former Member
Former Member over 7 years ago
For the first long ride with my new Edge 1030, i have a bug.

The screen was frozen after 1h33 of ride : the only way to regain control was to reset the Edge 1030.

You can see the result of the activitie on the photo uploaded : During the time the device was frozen, no data was recorded.
The version of my Edge 1030 is : 3.90.

Is there any correction for this problem ? ciq.forums.garmin.com/.../1324197.jpg
  • 0 over 4 years ago

    Seeing this on our 1030 V.10 and 830 V.6, running both on our tandem.

    On GPS only, both locking up coming out of a poor or zero reception area. Soft reset brings back the ride but no data from the lock point. Today I ran GPS+Glonass on the 1030, no issues. The 830 GPS only, locked up coming out of a wooded climb. After reset, the 830 with GPS+Glonass worked fine the rest of the day, ClimbPro worked normally. 

  • 0 over 4 years ago in reply to run50

    did you notice when that happen?

    yesterday, a friend with 9.50 found his 1030 shutdown ,after lost gps signal message

  • 0 over 4 years ago

    I notices same problem with FW 10.0

    Screen sometimes freezes, but in the background recording my ride continues.

    Freezes while switchting between screen.

    This week also freeze several times just after ClimbPro has finished climb and it goes back to the screen wirh the map/route.

    The screen of map appears and than freezes.

    I can press start/stop and hear beep, but nothing on screen. Must press power button for about 10 seconds to restart. It comes back in the ride and I can continue my ride without losing data.

    Donald Groen

  • 0 over 4 years ago

    I'm running v10.0 on a 1030.. First ride with this SW the distance to go and ETA froze but the map continued navigating with prompts.. No data was lost. 

  • 0 over 4 years ago in reply to Dawesboy

    I disabled today bluetooth on my iPhone because it freezed on Monday at the moment there was also a message from my iPhone.  But today freeze happened again.

    Donald Groen

  • 0 over 4 years ago in reply to hotdogpartysausage

    Me too. Since FW 9.x i have Issues mostly with activated Climb Pro. I can't do rides longer than 90 Minutes without Hard Reboot